Induction Motors
5IK40A-CW2BSJ
Motor
Questo prodotto non è più disponibile per la vendita.
| Classificazione prodotto | Nome del prodotto | Prezzo di listino | Data di spedizione |
|---|---|---|---|
| Motor | 5IK40A-CW2BSJ | - | Prodotto fuori produzione (1.4.2015 fuori produzione) |
Incluso
- Motor, Capacitor, Capacitor Cap, Operating Manual
Specifiche
Dimensioni
Capacitor
Scarica i dati
Altre Specifiche
General Specifications
| Item | Specifications |
|---|---|
| Insulation Resistance | After rated operation at normal ambient temperature and humidity, the measurement between the coils and the case is 100 MΩ min. using a 500 VDC megger. |
| Dielectric Strength | After continuous rated operation at normal ambient temperature and humidity, no abnormalities were observed even with an application of 1.5 kV at 50 Hz or 60 Hz between the coils and the case for 1 minute. |
| Temperature Rise | A gearhead or equivalent heat sink* is connected to the motor and the winding temperature rise is measured at 80 °C max. using the resistance change method after continuous rated operation under normal ambient temperature and humidity. (Three-Phase type is 70 °C max.) |
| Thermal Class | 130 (B) |
| Overheat Protective Device |
Thermal protector operating temperature Open: 130±5 °C, Return: 90±15 °C (normally closed) |
| Operating Ambient Temperature | Single-phase 100 V, single-phase 200 V, three-phase 200 V: -10~+50 °C (Non-freezing) Other voltages: -10~+40 °C (Non-freezing) |
| Operating Ambient Humidity | 85 % max. (Non-condensing) |
| Degree of Protection | IP65 (Excluding mounting surface of the round shaft type) |
- * Heat Sink Size (Material: Aluminum)
| Motor Type (Output Power) | Size (mm) | Thickness (mm) |
|---|---|---|
| 6 W type | 115 x 115 | 5 |
| 15 W type | 125 x 125 | |
| 25 W type | 135 x 135 | |
| 40 W type | 165 x 165 |
Permissible Radial Load and Permissible Axial Load of Round Shaft Type
Permissible Radial Load
| Motor | Permissible Radial Load N | ||
|---|---|---|---|
| Frame Size □ (mm) | Output Shaft Diameter φ (mm) | From Shaft End 10 mm |
From Shaft End 20 mm |
| 42 | 5 | 40 | - |
| 60 | 6 | 50 | 110 |
| 70 | 6 | 40 | 60 |
| 80 | 8 | 90 | 140 |
| 90 | 10 | 140 | 200 |
| 12 | 240 | 270 | |
Permissible Axial Load
Avoid axial load as much as possible. If an axial load is unavoidable, keep it at half or less of the motor mass.
Configurazione del sistema
Cavi e accessori
close