Q.I want to use the NETC02-CC and AZ Series to execute "positioning operation" or "continuous operation." What should I do after setting the data?

Use remote I/O to run it.

Remote I/O (Click on the screen to enlarge)
Example) When driving AZ Series (address number 0) in combination with Mitsubishi Electric Corporation’s CC-Link communication unit

• *The start address varies depending on the CC-Link station number setting. The table below shows an example of starting with Y1000 and X1000.

By using the technical support tool address calculation for NETC02-CC, the "NETC02-CC" and "CC-Link Communication Unit" can be combined to easily calculate the remote I/O and remote register addresses.
 

How to Execute Positioning Operations
Example) When positioning operations are performed with operation data No. 0

The following operations are used to perform positioning operations with the specified data.

[1]

By setting NET-IN0 (M0) = "OFF," NET-IN1 (M1) = "OFF," and NET-IN2 (M2) = "OFF," operation data No. 0 will be selected.
 

[2]

When NET-IN3 (START) = "ON," positioning operation starts.

[3]

Turn NET-IN3 (START) to "OFF."

How to execute continuous operations
Example) When continuous operations are performed with operation data No. 0

The following operations are used to perform continuous operations with the specified data.

[1]

By setting NET-IN0 (M0) = "OFF," NET-IN1 (M1) = "OFF," and NET-IN2 (M2) = "OFF," operation data No. 0 will be selected.
 

[2]

When NET-IN14 (FW-POS) or NET-IN15 (RV-POS) is set to "ON," continuous operations will start.

[3]

Operations stop when NET-IN14 (FW-POS) or NET-IN15 (RV-POS) is set to "OFF."