5IK100VEST2-GHR120

Note

• No built-in overheat protection device (thermal protector).
  When there is an overload or the output shaft is locked, use the electromagnetic switch and the inverter's electronic thermal function to prevent motor burnout.

• * The IP indication that shows the watertight and dust-resistant performance is specified under IEC60529 and IEC60034-5.
  For materials and surface treatment, refer to the table below.

About Load Position

Calculating the Permissible Radial Load for Hollow Shaft Type

When the end of the load shaft being driven is not supported by a bearing, as shown in the figure on the right, calculate the permissible radial load using the following formula.
(This mechanism is the most demanding state in terms of radial load.)

• When the gear ratio is 5~40

\(\begin{align} \text{Permissible Radial Load} \ W [\mathrm{N}] = \frac{83.5}{83.5 + Lp} \times 1340 \ [\mathrm{N}] \end{align}\)

1340 [N]:

Permissible Radial Load at the Flange-Mounting Surface Position
 

• When the gear ratio is 50~240 gear ratio

\(\begin{align} \text{Permissible Radial Load} \ W [\mathrm{N}] = \frac{83.5}{83.5 + Lp} \times 2460 \ [\mathrm{N}] \end{align}\)

2460 [N]:

Permissible Radial Load at the Flange-Mounting Surface Position
 

Always connect an electromagnetic switch when connecting the motor power supply.
Use an electromagnetic switch from the following product list, or an equivalent.
Set the rated current of the motor for the stabilized current of the thermal relay.
For the rated current of the motor, check the specifications for each product.

Fuji Electric FA Components & Systems Co., Ltd.

• * The winding code is specified where the box □ is located in the part number.

Manufactured by Mitsubishi Electric Corporation

When using in combination with an inverter, the setting frequency conditions of the inverter are as follows.
Refer to the operating manual for motor settings and precautions.